The first step to changing a tire is knowing you have the right tools to get the job done. All cars are different size bolts but if you know where your owner's manual is or even your spare tire set is then you will know the size. Usually when your tire pops you use a spare tire you have located in rather your trunk or underneath your car. The tools that should be in the set is The tire, jack, and the crow bar.
The second step is taking the tire off. First of all your going to want to make sure if your on the highway make sure you pull over far enough so your not blocking the high way, because the last thing you want to do is slow people down on the highway. After pulled over far enough on the road you plan to switch your tire on you should get your tools out. First your going to want to loosen the lug nuts before jacking it up. If you jack it up before loosening …show more content…
The first thing your going to want to do is put the tire and then stabilize it by putting the lug nuts you have on it. You wont be able to hand tighten the lug nuts so just make sure you have the lug nuts put on so the tire doesn't keep falling off. When your get all the bolts on again you will have to tighten them in a certain pattern. Depending on how many lug nuts you have. If you have five lug nuts then you will want to go in a star pattern so you know the tire is secure. For a four lug nut tire it’s a cross pattern so you got to the one of the opposite nut you just tightened until you get them all tightened. Those are usually the amount of lug nuts on a average car mini van or