The first step is ordering the CPAP machine. It comes with S9 device and an H5i device humidifier, power supply unit, tubing, and assembled mask unit.
The second step, you need a nightstand or flat surface next to the bed. On the flat surface, align the S9 device and the H5i humidifier. Push them together until they click. Connect the plug of the power supply unit to the rear of the S9 device. Connect the power cord …show more content…
You need to pull out the mask assembly and inspect for any cracks and then connect it to the air tubing. Ensure it on tight, so the air does not leak out.
The fifth step is filling your H5i water tub. Slide the silver latch on the front of the device and lift open the flip lid. Remove the water tub. Through the center hole, fill the water tub with room temperature (do not use hot or cold) distilled water up to the max water level mark. Warning! Filling the water tub while still in humidifier may damage the unit, voiding warranty. Overfilling the water tub may result in water splashing through the tubing. Return the water tub to the H5i. Close the flip lid, ensuring that it clicks into place.
The sixth step is operating. Press the start/stop button to start and stop your treatment. After a few seconds, the menu will automatically open to your humidifier setting. If the smart start/stop feature is enabled, simply breathe into the mask to start the flow of air. Airflow will shut off after a few seconds when the mask is removed. Warning! Airflow may stop if there is a high leak from your mask or tube. If this should happen, pull the mask away from your face and check for a secure fit. Make sure not to overtighten mask as this can increase leak. Adjust your humidifier setting by first turning the dial, then press down on the dial to lock in the desired settings. The screen