Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
25 Cards in this Set
- Front
- Back
What are the two basic types of hose used in military aircraft and related equipment?
|
Synthetic rubber and Teflon®.
|
|
What material is used to cover a Teflon® hose?
|
Braided stainless steel wire.
|
|
How is a synthetic rubber hose identified?
|
Indicator stripe and markings stenciled along the length of the hose.
|
|
A hose fitting consists of what separate parts?
|
Nipple, socket, swivel nut or flange, and the sleeve.
|
|
What color is an aluminum alloy 2024 hose fitting?
|
Blue.
|
|
How are commercially manufactured hose assemblies identified?
|
Identified by a band near one end of the assembly.
|
|
How are locally fabricated hose assemblies identified?
|
Hose assembly identification tag or label.
|
|
What type of cover is used to protect a hose assembly that is subjected to high temperatures?
|
Firesleeve.
|
|
All hose assemblies manufactured in a shop must have what test completed before they are installed on an aircraft?
|
Either a hydraulic or pneumatic pressure test.
|
|
What is the first thing you must do when you discover a swivel nut leaking?
|
Check for proper torque.
|
|
What is the acceptance life for a synthetic rubber hose assembly?
|
Eight years (32 quarters) from the cure date.
|
|
What is the service life of a synthetic rubber hose assembly that is exposed to the weather, fuel, or heat?
|
Seven years (28 quarters).
|
|
How are rigid tubing assemblies sized?
|
Outside diameter and wall thickness.
|
|
What type of tubing is used in a high-pressure hydraulic system that has 3000 psi or above?
|
Corrosion-resistant steel (CRES).
|
|
What type of tubing is used for general-purpose lines?
|
Aluminum alloy tubing.
|
|
What color is a carbon steel tube fitting?
|
Black.
|
|
What manual must you refer to when fabricating a tube assembly?
|
NA 01-1A-20.
|
|
What is the primary objective when cutting a piece of tubing?
|
To produce a square end free from burrs.
|
|
What must be done to a tube immediately after it has been cut?
|
Remove all burrs.
|
|
What is the primary objective when bending a piece of tubing?
|
Obtain a smooth bend without flattening the tube.
|
|
What are the two types of tube joints used on naval aircraft?
|
Flared and flareless.
|
|
What is used to lubricate the threads of a hydraulic line prior to installation?
|
MIL-H-5606 hydraulic fluid.
|
|
What is the preferred cleaner for cleaning a tube assembly?
|
Dry-cleaning solvent MIL-PRF-680.
|
|
The depth of a dent in a tube assembly must not exceed what percentage of the tubing diameter?
|
Twenty percent.
|
|
How many different types of repairs can be made on a tube assembly?
|
Two, permanent and temporary.
|