Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
50 Cards in this Set
- Front
- Back
- 3rd side (hint)
What do AFL and PFL stand for?
|
After-Fade Listen and Pre-Fade Listen.
|
|
|
What does DOS stand for?
|
Disk Operating System
|
|
|
What does DSP stand for?
|
Digital Signal Processor
|
|
|
What does MDM stand for?
|
Modular Digital Multitrack
|
|
|
What does RF stand for?
|
Radio Frequency
|
|
|
What does SPL stand for?
|
Sound Pressure Level
|
|
|
What does THD stand for?
|
Total Harmonic Distortion
|
|
|
What does an ACTIVE circuit contain, that a PASSIVE circuit doesn't?
|
Transistors, ICs, tubes, and other devices that require power to operate, and are capable of amplification
|
|
|
What does an auto-locator do?
|
Stores specific locations on tape, which can be re-called later
|
|
|
What is 'bouncing'?
|
Mixing two or more tracks together, and recording them onto another track
|
|
|
What is 'balance'?
|
The relative (volume) levels of left/right or different instruments within a mix
|
|
|
What is 'foldback'?
|
Feeding one or more separate mixes to performers when recording and overdubbing; also known as 'cue mix'
|
|
|
What does the 'aux' control do?
|
Routes signal out to an external module, eg. FX
|
|
|
How does a bandpass filter work?
|
It removes/attentuates frequencies above or below set levels, and emphasizes the frequencies between.
|
|
|
What is 'CV', and what does it do?
|
Control Voltage; used to control pitch of oscillator or filter frequency
|
|
|
What is analogue synthesis?
|
Waveforms/sounds created by analogue circuitry, usually filtering simple, repeating waveforms
|
|
|
What is additive synthesis?
|
Waveforms/sounds created by combining basic waveforms with filters and envelope shapers
|
|
|
What is subtractive synthesis?
|
Waveforms/sounds created by filtering and shaping a raw, harmonically complex waveform
|
|
|
What is a patch?
|
A single pre-programmed sound that can be recalled
|
|
|
What does the 'Local On/Off' do on a synthesizer?
|
Allos the keyboard and oscillators to be used separately of each other
|
|
|
What is the name for a synthesizer without a keyboard?
|
Expander Module
|
Korg M3M
|
|
What is 'active sensing'?
|
Where a sending MIDI device sends frequent short messages to the receiver device, to ensure the connection is working
|
|
|
How does an arpeggiator work?
|
Allows a MIDI instrument to sequence around any notes currently being played, usually over several octaves
|
|
|
What does a MIDI Analyser do?
|
Gives a visual readout of MIDI activity when connected between two MIDI devices
|
|
|
What is MTC?
|
MIDI Time-Code; a MIDI Sync Implementation
|
|
|
What does MIDI Controller Data do?
|
Sends information about the position of wheels, pedals, switches, etc.
|
|
|
How does quanitising work?
|
Moves notes recorded into a MIDI sequencer into set parameters, eg; crotchets, quavers, etc.
|
|
|
What is an algorithm?
|
A computer program designed to perform a specific task
|
|
|
What is ambience?
|
Sound reflections in a confined sense added to the origianl source sound, which gives a sense of space
|
|
|
What does an amplifier do?
|
Increases the level of an electrical signal
|
|
|
If something is 'analogue', how does it work?
|
Uses a continually changing voltage or current to represent a signal
|
|
|
What is ASCII, and what does it do?
|
American Standard Code for Information Interchange; code for representing keyboard characters in binary data
|
|
|
How does a capacitor microphone work?
|
By measuring the change in electrical charge across a thin conductive membrane inside the microphone
|
|
|
How is the chorus effect created?
|
By doubling the signal, and adding delay and slight pitch modulation
|
|
|
When does 'clipping' occur?
|
When a signal attempts to exceed the maximum level that a piece of equipment can handle
|
|
|
What is damping?
|
The rate at which reverberant energy is absorbed by surfaces in the environment
|
|
|
What does DCO stand for?
|
Digitally Controlled Oscillator
|
|
|
What does DI stand for, and what is it?
|
Direct Injection; when a signal is plugged directly into an audio chain, without a microphone
|
|
|
How does a dynamic microphone work?
|
On the electric-generator principle, where a diaphragm moves a coil of wire within a magnetic field
|
|
|
What does the term 'envelope' describe?
|
The way in which the level of a sound or signal varies over time
|
|
|
What is a 'glitch'?
|
An unwanted short-term corruption of a signal, or malfunction of a piece of equipment
|
|
|
What is a 'ground loop' or 'earth loop'?
|
Wiring fault, where multiple ground conenctions cause audible mains hums to be picked up
|
|
|
If you initialise a piece of equipment, what do you do to it?
|
Restore it to its factory settings
|
|
|
What is an interface?
|
A device that acts as an intermediary between two or more other pieces of equipment, eg-a MIDI interface allows a computer to communicate with MIDI instruments
|
|
|
What does a limiter do?
|
Controls the gain of a signal to prevent it ever exceeding a set level
|
|
|
How does noise shaping work?
|
Moves and added noise to part of the audio spectrum where human hearing is less sensitive
|
|
|
What is the 'sample rate' a measurement of?
|
The number of times an A/D converter samples a waveform per second
|
|
|
What is sibilance, and how is it usually caused?
|
A whistling or lisping sound, caused by poor mic technique or excessive equalisation
|
|
|
What does a transducer do?
|
Convertes one form of energy to another, eg. a microphone, which converts mechanical energy to electrical energy
|
|
|
What does a VU Meter do?
|
Interprets signal levels in roughly the same way as the human ear, which responds more closely to the average levels, than peak levels
|
|