Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
16 Cards in this Set
- Front
- Back
Atomizing type burners were designed to burn which type of fuel. |
#2 oil one gallon of number 2 fuel oil contains approximately |
|
One gallon of # 2 fuel oil contains approximately |
140,000 BTU's |
|
Pour point problems with outside above ground fuel tanks to be partially relieved by |
All of the above |
|
A fuel oil storage tank cannot be installed |
in the furnace room within 5 feet of heating unit |
|
The primary purpose of a fuel pump on a high pressure burner is to |
All of the above |
|
If the vacuum reading is substantially above the calculated reading (with the burner running) the cause maybe |
All of the above |
|
With most new retention burners the motor speed is |
3450 rpm |
|
To check the proper nozzle line cut off the pressure gauge is installed in the |
Nozzle port |
|
Fuel units are generally set at the factory at |
100 psi |
|
The oil burner nozzle in a high pressure burner performs the following functions |
All of the above |
|
Nozzle flow rates spray angle and pattern are directly related to |
All of the above |
|
Cold oil or high viscosity problems may be eliminated by |
A and b |
|
The following conditions or elements affect choosing the correct nozzle spray patterns |
A and b |
|
Which condition affects nozzle spray droplet size |
Fuel pump pressure |
|
To burn one pound of fuel it takes how many pounds of air |
14.4 lbs |
|
A layer of soot 1/16" thick will increase fuel consumption by |
4% |