Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
103 Cards in this Set
- Front
- Back
What GRC-206 component provides the controls and connectors to interconnect system power to the power junction unit that distributes power to the radio sets?
|
PDU
|
|
Which switch position on the power switchboard lets you operate from vehicle battery power and bypass the oil pressure sensor switch?
|
VEHICLE OVERRIDE
|
|
The overcurrent protection switch on the GRC-206 power switchboard provides overcurrent protection when amerage reaches---
|
50 amperes
|
|
GRC-206 connector that joins the fiber-optic input cable to RSC---
|
J1/J2
|
|
Component of the GRC-206 that stores, maintains, and transfers the TOD message---
|
RFO
|
|
At a maximum, how long can the internal battery in the RFO on the GRC-206 maintain the TOD after loss of system power?
|
15 minutes
|
|
How long will the light on the RFO stay lit during initial turn-on procedure of the GRC-206?
|
Up to 15 minutes
|
|
What does it indicate when the lamp on the RFO is lit?
|
RFO does NOT contain a TOD
|
|
Which key on the RSC selects COMSEC enable function?
|
1
|
|
Which dual function key on the RSC turns the ECCM capability on/off?
|
5/ACT
|
|
Which dual-function key on the RSC enables the UHF-AM to receive a TOD signal?
|
8/TOD
|
|
Which dual-function key on the RSC disables the COMSEC override mode?
|
0/PST
|
|
What audio status alarm is heard when there is an open fiber-optic cable fault?
|
390-hertz tone
|
|
What are the three lengths of fiber-optic cable supplied with the GRC-206?
|
1 km, 50 ft, 20 ft
|
|
Antenna consisting of eight 4-foot sections and must be guyed when it's over 16 ft high---
|
HF
|
|
Antenna that has a mechanical antenna-matching unit that electronically matches antenna length with selected frequency---
|
VHF-FM
|
|
What will the MONITOR/TEST window on the URC-113 display during power up if the radio is operating normally?
|
8, 0, then go blank
|
|
On the AM-7148 amplifier-coupler, what letter is displayed in the MONITOR/TEST window if an invalid frequency has been entered?
|
F
|
|
On the AM-7148 amplifier-coupler, what letter is displayed in the MONITOR/TEST window if the RT-1444 fails?
|
E
|
|
On the AM-7148 amplifier-coupler, what letter is displayed in the MONITOR/TEST window if the amplifier-coupler or antenna fails?
|
A
|
|
Operating frequency range of the VRC-91A---
|
30.000-87.975
|
|
What is the frequency spacing on the VRC-83(V)2 UHF-AM/VHF-AM radio?
|
25-kHz steps
|
|
What are the three lengths of fiber-optic cable supplied with the GRC-206?
|
1km, 50ft, 20ft
|
|
Antenna consisting of eight 4 foot sections and must be guyed when it's over 16 ft high-
|
HF antenna
|
|
Antenna that has a mechanical antenna-matching unit that electronically matches antenna length with selected frequency-
|
VHF-FM antenna
|
|
What will the MONITOR/TEST window on the URC-113 display during power up if the radio is operating normally?
|
8, 0, then go blank
|
|
On the AM-7148 amplifier-coupler, what letter is displayed in the MONITOR/TEST window if an invalid frequency has been entered?
|
F
|
|
On the AM-7148 amplifier-coupler, what letter is displayed in the MONITOR/TEST window if the RT-1444 fails?
|
E
|
|
On the AM-7148 amplifier-coupler, what letter is displayed in the MONITOR/TEST window if the amplifier-coupler or antenna fails?
|
A
|
|
Operating frequency range of the VRC-91A
|
30.000-87.975
|
|
Frequency spacing on the VRC-83(V)2 UHF/VHF-AM radio
|
25-kHz steps
|
|
What is the power output of the VRC-83(V)2 UHF/VHF-AM radio when it's operating in the PA mode?
|
30 watts
|
|
What is the power output of the VRC-83(V)2 UHF/VHF-AM radio when the RT-1319B/URC is in high power and the PA is in the BYPASS mode?
|
10 watts
|
|
When entering a frequency manually on the VRC-83 radio, how many seconds do you have to press the enter key before the radio returns to the previous frequency?
|
30 seconds
|
|
After changing a VHF-FM radio preset channel on the RSC, how long must you wait before another preset channel entry can be accepted?
|
5 seconds
|
|
What is the maximum number of operators that may transmit on an(one) RSC?
|
4
|
|
How long does the CALL prompt on the RSC display stay lit after the receiver has been squelched?
|
6 seconds
|
|
The entry that programs the frequency-hopping rate and pattern on the RT-1319B/URC
|
WOD
|
|
The function that places one radio in synchronization with all other similarly operated radios
|
TOD
|
|
When using the RT-1319B/URC in ECCM mode, how many possible net numbers are there?
|
1,000
|
|
To start HAVEQUICK II ops on the URC, what operations code must you enter into "preset 20" to let you OPERATE/VERIFY?
|
220.000
|
|
Maximum number of WOD entries you can load into a HAVEQUICK II capable radio
|
6
|
|
On the RT1319B/URC, what preset would you enter today's operational date code into?
|
1
|
|
On the GRC-206(V)5, what is the rating in amperes of circuit breaker 1?
|
70 amperes
|
|
Which port on the DCT printer power supply provides +8 VDC for use with the DCT?
|
J1
|
|
How many channels per second can the URC-113A scan using ALE mode?
|
5
|
|
The RSC must be powered with internal batteries when it is remoted more than how many feet?
|
50 ft
|
|
Which RT position on the GRC-206 (V)5 RSC is used for the UHF-AM radio?
|
RT-1
|
|
Which RT position on the GRC-206 (V)5 RSC is used for the HF-SSB radio?
|
RT-2
|
|
Which RT position on the GRC-206 (V)5 RSC is used for the VHF-FM radio?
|
RT-3
|
|
How long will the open cable light on the GRC-206 (V)5 RSC remain lit during power up?
|
2 seconds
|
|
Which menu on the GRC-206 (V)5 provides access to program the operating parameters for the radio subsystems?
|
Menu list
|
|
What radio set is a dual-band radio that can operate in the VHF-AM and the UHF-AM frequency spectrums?
|
PRC-113
|
|
Power output of the PRC-113
|
2 or 10 watts selectable
|
|
VHF-AM freq range of the PRC-113
|
116.000-149.975 MHz
|
|
UHF-AM frequency range of the PRC-113
|
225.000-399.975
|
|
What is the transmitted power output of the PRC-104?
|
20 watts
|
|
Depending on terrain, what is the nominal range of the PRC-104?
|
10 miles
|
|
When using the PRC-104, what does a continuous clicking noise during transmission indicate?
|
Low battery
|
|
When using the PRC-104, what fault indication is given when the radio retunes each time the handset is keyed?
|
Voltage standing wave ratio (VSWR) indicator
|
|
Which radio is used to communicate on the Army command/control, fire support, and internal TACP net?
|
AN/PRC-119A
|
|
In what position would you set the function switch on the PRC-119A to clear all frequency hop data?
|
Z-FH
|
|
How long will the HUB maintain memory and sync if the PRC-119A is placed in the STBY mode?
|
24 hours
|
|
In what position would you set the COMSEC switch on the PRC-119A to receive a remote fill?
|
RV
|
|
Name three functions of NCS
|
Control net access, maintain net discipline, open/close nets
|
|
What MODE selection could take you out of the net, and possibly stop your entire net from communicating?
|
FH-M
|
|
After you press the BATT button on the PRC-119A, what number will show if you need to replace the battery?
|
11 or higher
|
|
Into what position would you put the MODE switch on the KY-57 to receive variables over the radio from the NCS?
|
RV
|
|
Regarding the KY-57, who normally uses fill position number 6 to transmit the variables for fills 1-5 at the end of each time period?
|
NCS
|
|
Which connector on the KY-99 is the fill interface connector?
|
J2
|
|
Which position of the MODE control switch on the KY-99 would you use to zeroize all stored keys?
|
Z ALL
|
|
What secure comms system has no memory and only reads and transfers encrypted code?
|
KOI-18
|
|
What battery does the KYK-13 transfer mode interface use to maintain fill memory?
|
BA-5372/U
|
|
How many sets of SOI can be stored in the AN/CYZ-10 ANCD?
|
2
|
|
SOI best described as information on the time period, net name, call sign, net ID, manual freq, CUE freq, and call word?
|
Net
|
|
Regarding the ANCD, how many quick-reference nets may be stored in the quick reference file?
|
20
|
|
What segment of the GPS is a fixed ground-based segment responsible for tracking and updating satellite time and position?
|
Control
|
|
What segment of the GPS is a satellite system of 21 operational satellites and 3 active spares?
|
Space
|
|
What part of the GPS navigation message is used for synchronizing the clocks at the control, space, and user segments?
|
GPS time
|
|
Considering a GPS, what uses a high dynamic receiver?
|
Fast moving aircraft
|
|
What connector on the PSN-11, PLGR, provides external helmet antenna input?
|
J3
|
|
Battery used for primary power in the PSN-11 PLGR
|
BA-5800/U
|
|
What is the minimum battery life for the BA-5800/U when used with the PLGR?
|
10 hours
|
|
On page 1 of the PSN-11 menu, what option provides system, battery, antenna, satellite, and other status information?
|
STATUS
|
|
What option/function in the waypoint menu display lets you determine range, azimuth, and elevation angle from one waypoint to another?
|
DIST
|
|
After the NAV key on the PLGR is pressed, what option is used to show a course to the destination?
|
CRS TO
|
|
What key on the PSN-11 is used to store the present position as a waypoint?
|
MARK
|
|
What is the maximum time for a PSN-11 cold start?
|
15 min.
|
|
On the PRC-117F, what connector is used to connect an external GPS receiver?
|
J2
|
|
On the PRC-117F KDU, which button accesses the KDU backlight controls?
|
LT
|
|
How many COMSEC keys for each COMSEC type can the PRC117F hold?
|
25
|
|
Prior to connecting the AN/CZY10 ANCD to the PRC-117F, the function switch must be in what position?
|
LD
|
|
When programming the PRC117F, what are the maximum allowable alphanumeric characters shown in net presets?
|
12
|
|
On the PRC117F, which menu item (when entered) will automatically enter the proper satellite downlink and uplink frequencies?
|
FREQ CODE
|
|
Which COMSEC type is for voice op only?
|
FASCINATOR
|
|
Which COMSEC type is for data op only?
|
KG-84
|
|
What is the power level range for SATCOM programming?
|
2-20 watts
|
|
What is the maximum transmission power for the SINCGARS mode?
|
10 watts
|
|
When using the PRC117F, in what increments cna the power setting on the SINCGARS mode be adjusted?
|
1dBm
|
|
When manually entering the GTOD, the last two digits of which date must be determined and entered for the day component of the time entry?
|
Julian date
|
|
On the PRC117F, what is the transmission power selection for HAVEQUICK operations?
|
1-10 watts
|
|
The length of time the radio dwells on a net after a signal ends before returning to scan---
|
hang time
|
|
The length of time the radio dwells on a net before returning to scan, even with a signal present---
|
hold time
|