Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
51 Cards in this Set
- Front
- Back
|
Cone socket mouth mirror-used for visual examination, reflection of light, and to retract tissues. |
|
|
Simple Stem mouth mirror- used for visual examination, reflection of light, and to retract tissues. |
|
|
Perio probe- used to measure the depth of the gingival sulcus during the patient's oral exam. |
|
|
Discoid Spoon Excavator- used to remove soft decay from dentin of prep. |
|
|
Spoon Escavator- used to remove soft decay from the dentin in the prep.. |
|
|
Enamel Hatchet- used to plane enamel on buccal and lingual axial walls on Class II preps. |
|
|
Off-Angled Hatchet- used to plane enamel on the buccal and lingual axial walls on Class II preps. |
|
|
Straight Chisel- used to plane enamel on the labial and lingual axial walls of Class III and IV preps. |
|
|
Wedelstaedt Chisel- used to plane enamel on the lingual axial walls on Class III and IV preps. |
|
|
Mesial Margin Trimmer- used to plane the mesial gingival margin on Class II inlay & onlay preps. |
|
|
Distal Margin Trimmer- used to plane the distal gingival margin on Class II Inlay & Onlay preps. |
|
|
Hoe, anterior- used to plane pupal floor of Class III and IV preps. |
|
|
Special Hoe, Posterior- used to plane the pupal floor of Class I and II preps in an amalgam procedure. |
|
|
Amalgam condenser- used to pack and condense amalgam or cement into a prepared cavity preparation. |
|
|
Discoid-cleoid carver- used to carve amalgam on the occlusal surfaces of the posterior teeth. |
|
|
Hollenback Carver- used to carve interproximal surfaces of restoration. |
|
|
Interproximal Carver- used to carve the interproximal surfaces of the amalgam restoration. |
|
|
Frahm's Carver- used to carve occlusal surfaces of amalgam restorations on posterior teeth. |
|
|
Wall's carver- used to carve the occlusal surface of amalgam restorations on posterior teeth |
|
|
Egg/Ball Burnisher- is used to burnish or smooth the margins of metallic restorations. |
|
|
Ball Burnisher- is used to burnish or smooth the margins of metallic restorations. |
|
|
Beavertail burnisher- used to burnish or smooth the margins of metallic restorations. |
|
|
Articulating paper holder- Used to hold articulating paper to check occlusal surfaces. |
|
|
Tofflemire retainer- holds the matrix band snugly in position.
|
|
|
Universal Matrix Band- thin flexible steel band. Used in tofflemire retainer. |
|
|
Gingival retraction instrument- used to pack gingival retraction cord during crown prep or gold prep procedure. |
|
|
PFI instrument- convey and pack dental cements & composite into prepared cavity prep. |
|
|
Plastic composite instrument- used to convey & pack composite materials into prepared cavity preps. |
|
|
Flexible spatula- used to mix various dental cements and materials. |
|
|
Wax Spatula- used to carry hot wax to prepared tooth. |
|
|
Wax carver- used to carve wax patterns in prepared teeth.` |
|
|
Jacquette scaler- used to remove hard deposits of calculus and stain from surface of tooth by hand. |
|
|
Sickle scaler- used to remove hard deposits of calculus from surface of tooth by hand. |
|
|
Curette- remove hard deposits from the surface of the tooth by hand. |
|
|
Crown & Bridge Scissors |
|
|
Crown & Bridge remover- used to remove a crown or bridge after it has been seated with permanent cement, such as zinc phosphate. |
|
|
Prop- used to assist the mouth in remaining open. |
|
|
Gag- used to assist the mouth in remaining open |
|
|
Dappen dish- hold pastes & liquid during a packing in carrier. |
|
|
Amalgam well- used to hold the amalgam. |
|
|
Svedopter- used to isolate the area prior to seating a crown on mandibular arch. |
|
|
Cotton roll holder- used to hold cotton rolls in place on mandibular arch. |
|
|
Composite syringe- used to extrude the composite resin into a cavity prep. |
|
|
Boley Gauge- used to measure in millimeters. |
|
|
Scalloping scissors- used to trim vinyl & |
|
|
Crimping Pliers- used to crimp the edges of a temporary crown to reduce circumference. |
|
|
Belling Pliers- used to bend the edges of a temporary crown. |
|
|
Contouring Pliers- used to contour or roll the edges of a temporary crown. |
|
|
Dental Dam Punch- used to create holes in the dental dam. |
|
|
Rubber Dam Forceps- used to place and remove dental dam clamp. |
|
|
Young frame- holds the dam in place during procedure. |