Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
20 Cards in this Set
- Front
- Back
To isolate AC Bus 1 from the electrical system:
|
press in the left AUTO XFER switchlight, turn off the #1 generator.
|
|
Once disconnected, the IDG:
|
can only be reconnected on the ground by maintenance.
|
|
The ADG supplies AC power to hydraulic pump:
|
3B, and the AC Essential Bus.
|
|
The ADG is rated at:
|
115 VAC 15 KVA.
|
|
115 VAC is converted to 28 VDC by the:
|
Transformer Rectifier Units.
|
|
With a TRU 1 failure, DC Bus 1 can be powered :
|
automatically or manually by the SERVICE TRU when TIE 1 closes.
|
|
An ESS TRU1 caution message indicates that TRU output is less than:
|
18 volts.
|
|
A failure of AC BUS 2 will result in the loss of ___ TRU(s)?
|
3
|
|
IDG 1 normally powers
|
AC Bus 1, AC Essential Bus, AC Utility Bus 1.
|
|
After ADG deployment, and a normal source of AC power is re-established.
|
The PWR TXFR OVERIDE switch will allow a normal AC power source to power the AC ESS Bus.
|
|
Engine starting requires air from the APU, ground air cart, or
|
60 psi minimum, 10th stage engine cross bleed air.
|
|
Ignition system B is powered from the:
|
DC Battery Bus.
|
|
At low power settings (N1 less than 79%), the engine is on:
|
N2 speed control, regardless of Speed switches position.
|
|
The left Engine Start switch/light, when pressed in opens the:
|
left and right 10th SOV's, 10th isolation valve, and left air turbine starter valve.
|
|
During thrust reverser deployment:
|
both the wing and cowl anti-ice valves close.
|
|
Scavenge ejectors and gravity feed lines transfer fuel from the:
|
main tanks to the collector tanks.
|
|
How is fuel balance maintained between the main fuel tanks?
|
Manually by the gravity crossflow valve.
Automatically by the XFLOW/APU pump and associated shutoff valves. |
|
If the high pressure engine driven fuel pump fails:
|
the engine flames out.
|
|
Fuel is supplied to the APU by the:
|
XFLOW/APU pump from both main tanks.
right engine supply line (if pressurized), under negative g conditions. |
|
When the Boost Pump switch/lights are pressed in, the Boost pumps operate:
|
when low pressure is detected in an engine feed line.
|