Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
20 Cards in this Set
- Front
- Back
extent of part of a surface enclosed within a boundary |
area |
|
the act or process of or result of calculating |
Calculation |
|
group or category within an organized system |
Classification |
|
number expressed in a counting system that uses units of 10, especially a decimal fraction |
Decimal |
|
number expressed in a counting system that uses units of 10, especially a decimal fraction |
Dimension |
|
number expressed as a quotient of two other numbers |
Fraction |
|
characterized by straight line, regular curves and angles |
Geometric shapes |
|
– scale of a measuring tool |
Graduation |
|
– act or art of measuring |
Mensuration |
|
bounding line or curve of a plain area |
Perimeter |
|
serves as a measure of reference |
Standard |
|
refers to a lumber for a certain furniture job |
Stock |
|
wood to be cut in a cutting machine |
Substrate |
|
space inside a solid figure |
Volume |
|
what are the types of measuring tools? |
Pull push rule Zigzag rule Ruler Caliper Try square Meter stick Divider Compass Protractor |
|
DO'S ON HANDLING OF MEASURING TOOLS/ INSTRUMENTS |
1. Wipe measuring tools/instruments before returning them to the storage room. 2. Oil the movable parts of the measuring tools such as zigzag rules, calipers, dividers and compasses to avoid stock-up. 3. Make sure that grits like sand do not get inside the housing or case of a pull-push rule to avoid wearing off of the graduations. 4. Check the lock of a pull-push rule if it is working. |
|
DON'T'S |
1. Do not wipe off edges of the steel tape of pull-push rule with bare hands to avoid injury. 2. Do not pull the steel tape of pull-push rule too much to avoid the coil spring from damage. 3. Do not use the caliper as tongs. |
|
what are the 6 faces of lumber? |
End 1 End 2 Edge 1 Edge 2 Surface 1 Surface 2 |
|
what are the ways in taking dimension? |
1 Measure end to end of stock with a tool 2. Measure edge to edge with a tool 3. Measure outside diameter of a cylindrical object using a caliper 4. Measure inside diameter with a caliper 5.Lay-out width |
|
what is the formula for the BD. FT.? |
t x l x w /12 |