Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
15 Cards in this Set
- Front
- Back
|
Which of the following alignment measures mints and or angles are adjustable Toe and caster Toe out on turns Kingpin inclination Camera and kingpin inclination |
Toe And caster |
|
|
A vehicle has a front wheel towing condition. This means the distance between the centre lines of the tires at the front is greater than the distance between the centreline of the tires at the rear true or false |
False the description in the statement refers to a tow out condition |
|
Identify the following angles as Tire, wearing angles or directional control, steering stability angles |
Back (Definition) |
|
|
When viewed from the front of the vehicle, both front tires appear to have positive camber the tires are tilted |
Out at the top |
|
|
A vehicle has a single steering axle in a single drive axle the tow out on turns. Alignment setting will be correct when the outer front tire turns out a sharper angle, then the inner tire. True or false |
False inner steering tire turns a sharper angle |
|
|
When adjusting the tow setting on a rack and pinion steering gear, you must Centre of the rock by aligning the pointers on the input shaft, seal, cover, and Input shaft, housing Use a computerized multiple wheel alignment Adjust each tire rod by loosening the jam, nuts, and turning the inner Rod All of the above, |
All of the above |
|
|
Prior to doing a wheel alignment, tire and wheel/rim run out. Checks are done the toe setting could be affected if the lateral run out is beyond specifications True or false |
False |
|
|
Tire should be checked to see if they are match prior to a wheel alignment. Explain what might happen if the vehicle is on match tires on the front axle. |
The vehicle could pull to the side, having the smaller tire operator effort is increased to offset this pulling action |
|
|
Wheelbearings that are out of adjustment loose beyond allowable limits may affect to Will I am at settings, identify those to settings |
Teoe and camber |
|
|
Suspension components that are weak. For example, leaf springs, and sagging due to a bent axle, may affect to alignment settings identify those to settings |
Camber and caster |
|
|
Steering stops must be properly set what component might suffer damage if the stops are not set correctly too much in word movement during cornering |
The internal components within the steering gearbox may be damaged tires may also Rub on suspension components are body panels with resulting damage to the tires in these items |
|
|
The tow adjustment is typically done by loosening, both outer tie rod ends, and rotating the tie rod itself |
True |
|
|
Across tube that has been cut due to a collision with an obstacle in off-road conditions will affect which alignment measurements or angles Caster camber toe out on turns Toe |
Toe |
|
|
Positive caster projects, the point of Load ahead of the point of contact True or false |
True |
|
|
Explain how the king pin inclination angle in the toe out on turn angles can be corrected. It found to be outside allowable limits during the alignment process |
Replacement of damage Parts is the method used to bring these angles back into specification |
