Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
18 Cards in this Set
- Front
- Back
Which of the following is true about disk drive interfaces? |
PATA allows for two connectors on a motherboard |
|
Why might you want to use a RAID 0 disk configuration? |
to improve overall disk performance |
|
What should you keep in mind when installing hard drives? |
a PATA drive has master and slave settings |
|
Which interface is not typically used for an internal tape drive? |
FireWire |
|
Which type of cable is required by ATA/66 and above? |
40 pins, 80 wires |
|
Which SATA standard provides a transfer rate of 3 Gb/sec? |
SATA2 |
|
The top and bottom of each disk in a magnetic hard drive have a ____________ that moves across the disk surface. |
read/write head |
|
A _____________ has no moving parts and is built using nonvolatile memory, which is similar to that used for USB flash drives. |
solid state drive |
|
Which of the following is true about selecting a hard drive? |
magnetic drives have larger capacity for the money than solid state drives |
|
Which process writes sector markings to a hard drive? |
low-level formatting |
|
The read/write head on a magnetic hard drive is at both the top and bottom of each disk. |
True |
|
How much data does a 3.5" floppy disk drive hold? |
1.44 MB |
|
How is data stored on a magnetic tape? |
sequentially |
|
If you connect the floppy cable in the wrong direction, the floppy drive light stays on continuously. |
True |
|
What does a twist in a 34-pin data cable mean? |
it indicates drive A: |
|
Why would you use a round PATA ribbon cable instead of traditional flat cable? |
round cables obstruct air flow less inside the case |
|
With ___________, you can connect and disconnect a drive while the system is running. |
hot-swapping |
|
Each IDE header on a motherboard can support up to two IDE devices. |
True |